Lubrication Pinions

Until today, gear rings, eg. at wind power plants, tower cranes or construction and special machines, are mostly lubricated manually. However, by doing this, the lubricant gets pushed into the gear base or outwards via gear flanks. The resulting consequences are grave. They include, but are not limited to, imprecise lubricant distribution in contact areas, faulty dosages, increased waering, dripping of lubricant and the resulting environmental damage. Lubrication pinions are developed to prevent these consequences. They guarantee a tailored dosage and precise lubricant distribution in contact areas. The use of lubrication pinions ensures higher durability. The advantages include i.a. cost savings due to reduced lubricant use, extension of service intervals, higher system availability, operating cost reduction and environmental friendliness.

Procedure: Lubricant is delivered via lubrication pump into the axis and by that through a bore inside the lubrication pinion teeth's lubrication duct, which is currently interlocked with the gear ring. During this process, all other lubrication pinion teeth are not supplied with lubrication. The lubricant, flowing out at the gear flanks, is pressed exactly into the gear flanks' contact areas and evenly distributed via the lubrication pinion's rolling motion. The even distribution of lubricant over the whole tooth width is carried out with plates made of cell rubber. The gears are made of metal, are therefore very durable and resistent to all lubricants and environmental influences.

 


Lubrication pinion - environmentally friendly - reduction of operating costs

Lubrication pinion - environmentally friendly - reduction of operating costs
  • Lubrication pinion
  • Suitable for lubrication of gear rings and gear racks
  • Cost minimisation because of lower lubricant use
  • Prolonged service intervals
  • Reduction of operating costs
  • Environmentally friendly
MSRP 0,00 EUR net / piece
excl. 19 % VAT
Shipping time: 1-3 Days

Lubrication pinion - 8 teeth - for grease

Lubrication pinion - 8 teeth - for grease
  • Lubrication pinion
  • Suitable for grease
  • Made of PU and aluminium
  • Modules: 12, 14, 16, 18, 20, 22, 24
  • Teeth: 8
  • Temperature range: -40°C to +80°C
MSRP 0,00 EUR net / piece
excl. 19 % VAT
Shipping time: 4 Weeks
Show 1 to 2 (of in total 2 products) Sites:  1